This is the list of projects to finish off the aft machinery spaces. Much has
been done, these are the detailed list of things to complete.
Important things to get done.
- [ 0% Complete]
Mount compressor for fridge (Two Screws)
- [ 0% Complete]
Reroute/Install power feed for new autopilot mounting position
- [ 0% Complete]
Reroute/Install seatalk cable for new autopilot mounting position
-
"B" List
- [ 0% Complete]
Move Yaw rate transducer to aft engine bulkhead and reroute cable
- [ 0% Complete]
Trim Quadrant cables
- [ 0% Complete]
Vented loop for Damage Control Pump (2" water line)
- [ 0% Complete]
Clean base and remount watermaker, replace barb fitting and repickle
- [ 0% Complete]
Install backing plates for Tow/Drogue attachments
- [ 0% Complete]
Remote secondary 110 V power feed box
- [ 0% Complete]
Obtain and mount ST1000 autopilot power feed/seatalk line
- [ 0% Complete]
Beef up temporary turning block mounts for quadrant
- [ 0% Complete]
Rebuild electric bilge pumps
- [ 0% Complete]
Rebuild Exhaust fitting on transom
- [ 0% Complete]
Pod on helm for autopilot head, windlass control, vhf radio head, stereo
control
- [ 0% Complete]
Replace corroded clamps on exhaust hose
- [ 0% Complete]
Rework watermaker filter and line assembly
- [ 0% Complete]
Rebuild quadrant turning block assembly
- [ 0% Complete]
Reposition rudder angle transducer (reroute cables) to protect from cockpit
locker
- [ 0% Complete]
Install cockpit hard points
- [ 0% Complete]
install aft sail tracks
- [ 0% Complete]
install high power RF feed through on aft deck
- [ 0% Complete]
install teak door at aft end of quarterberth
- [ 0% Complete]
have refrigeration unit serviced due to low charge
- [ 0% Complete]
rewire compressor control circuit to terminal block instead of quick
couplers
- [ 0% Complete]
reblumb watermaker to avoid air entrainment
- [ 0% Complete]
install self steering vane turning blocks
- [ 0% Complete]
install shelf over transom exhaust lines to facilitate access/storage
- [ 0% Complete]
reroute wiring from propane control locker to controller
- [ 0% Complete]
reblumb washdown pump in cockpit
- [ 0% Complete]
epoxy propane inlet
Hardware movement for painting
- Galvanic Isolators
- Cockpit Bilge Pump
- Antenna Tuner
- Propane Control Locker
- Watermaker Filter Assembly
- Primary Bilge Pump
- Engine Water Strainer
- Quadrant and Steering Gear
- Water lift Muffler
-
-